Advance Termite Bait System Kit 20-6

Advance Termite Bait System Kit 20-6. Termite Control Solution

Kit includes

20 Advance Termite Bait Stations
20 Advance Termite Monitoring Base's
20 Advance Termite Inspection Cartridges
6 Advance Termite Bait Cartridges
1 Spider Bait Station access tool

The station cap is opened with a special device called The Spider™. Inside the in-ground station is a combination of a highly preferred wood monitor and a Termite Inspection Cartridge (TIC) that contains Puri-Cell™ monitoring tablets, the pre-bait. Termites will initially feed and aggregate in the lower Termite Monitoring Base (TMB), then readily forage upward and feed on the Puri-Cell tablets. This combination enables you to inspect and detect termite activity in the station with minimal disturbance to termites in the station.

STATION INSTALLATION
To install a station, excavate or form a hole in the ground approximately the same size and dimensions as those of the station. Insert the station into the hole. Maximizing contact between the exterior of the station and the earth during installation will increase the probability of termite entrance into the station. If the station is inserted into an opening created through a hardened construction surface (such as a concrete slab, asphalt, etc.), insert station below the surface (in contact with the ground) and seal securely.

Placement
Place the Advance TBS in the soil around the perimeter foundation of a structure. You should identify critical areas where stations should be installed including, but not limited to, termite active tubes and infested wood. Other critical areas may include infested materials and areas conducive to termite activity including wood-to-soil contact, moist soil around downspouts, air conditioner drain lines, sprinkler heads and mulch beds. The recommended spacing between stations is 10 feet with the maximum spacing between stations not to exceed 20 feet if access to soil is unrestricted.

SCHEDULING OF INSPECTIONS
If termite activity is known to be present in the structure at the time stations are initially installed, inspect all stations two times at approximately 45 and 90 days after the date of completion of initial station installation. If no termite activity is present in the structure at the time stations are initially installed, inspect all stations for the first time within approximately 90 days after the date of completion of initial station installation. Thereafter, inspect stations within approximately 90 days after the date of the last inspection of the stations.

Manufactured by Whitmire Micro-gen

Advance Termite Bait Cartridge
* Used during baiting phase
* Contains 93 grams of compressed Puri-Cell™ bait matrix with .25% diflubenzuron
* Containerized for easy inspection Treatment Technique: Bait cartridge placed in stations once termites are present in station.

Advance Termite Inspection Cartridge * Used during monitoring phase
* Contains 93 grams of Puri-Cell™ monitoring matrix without active ingredient
* Quick transfer from wooden termite monitoring base (TMB)
* Promotes "harder hits"